Sony Ericsson W850i
disassembly
Tools required: Torx 6
screwdriver, Size 0 Phillips screwdriver
- Remove the two screws at the bottom
of the phone with the torx 6 screwdriver.
- Next push the slider up so you have
access to the metal plate, shown below. Run your finger around the
edge where the metal plate meets the housing to unclip it.
- With the metal plater removed you
have access to two more torx 6 screws. Remove these
- Run your fingernail all the way
around the edge of the housing to release it
- The phone will now be in two parts,
as below
- The screen assembly is held on by
two clips at each side of the phone, indicated below. Unclip them
- Unclip the board for the keypad by
lifting it from the right side. It attaches to two ribbons like a
plug and socket. The screen ribbon is also attached to the back of
this board: also detach this.
- Your phone should now look like the
picture below
- Reverse the whole procedure for
reassembly
|