Tools required: Torx 6 screwdriver, Size 0 Phillips screwdriver
- Remove the two screws at the bottom of the phone with the torx 6 screwdriver. Remove the other two screws with the Phillips screwdriver
- Lift the antenna cover away from the phone. It unclips at the top of the phone and needs a little force to remove
- Remove the two torx 6 screws at the top of the phone which are revealed after removing the antenna cover
- Pull the front cover away at each side so that it releases
- The phone will now be in two parts, as below
- Wiggle and pull the keypad assembly up, away from the phone and it will pop off
- The screen assembly is held on by two clips at each side of the phone, indicated below. Unclip them to remove the screen assembly
- Unclip the ribbon which hold the
screen assembly to the circuit board of the phone. It attaches like
a plug and socket
-
Detach the retaining clips on each side of the screen assembly
-
Remove the faulty screen and replace with the new screen
- Reverse the whole procedure for
reassembly